Search results
Results from the WOW.Com Content Network
An example schematic with one controller (a microcontroller), three target nodes (an ADC, a DAC, and a microcontroller), and pull-up resistors R p. I 2 C uses only two signals: serial data line (SDA) and serial clock line (SCL). Both are bidirectional and pulled up with resistors. [2]
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
MII has two signal interfaces: A Data interface to the Ethernet MAC, for sending and receiving Ethernet frame data. A PHY management interface, MDIO, used to read and write the control and status registers of the PHY in order to configure each PHY before operation, and to monitor link status during operation.
Vcc Vcc Type 2 CS MOSI MISO SCK GND Vcc Type 2A (extended SPI) CS1 GPIO/INT MOSI GPIO/RESET MISO GPIO/CS2 SCK GPIO/CS3 GND GND Vcc Vcc Type 3 CTS/GPIO TxD RxD RTS/GPIO GND Vcc Type 3A (extended UART) CTS/GPIO GPIO/INT TxD GPIO/RESET RxD GPIO RTS/GPIO GPIO GND GND Vcc Vcc Type 4 DIR EN SenseA SenseB GND Vcc Type 5 (dual H-bridge) DIR1
Some devices may expose such attributes in multiple "pages", as for example one page managing each power supply rail (maybe 3.3V, 5V, 12V, −12V, and a programmable supply supporting 1.0–1.8V). The device may set warning and fault limits, where crossing a limit will alert the host and possibly trigger fault recovery.
Example of a UART frame. In this diagram, one byte is sent, consisting of a start bit, followed by eight data bits (D1-8), and two stop bits, for a 11-bit UART frame. The number of data and formatting bits, the presence or absence of a parity bit, the form of parity (even or odd) and the transmission speed must be pre-agreed by the ...
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
Schematic symbol for a buffer with open-collector output [6] Open output is indicated on schematics with these IEEE symbols: [7] ⎐ – NPN open collector or similar output that can supply a relatively low-impedance low voltage when not turned off. Requires external pullup. Capable of positive-logic wired-AND connection.