enow.com Web Search

  1. Ads

    related to: rear mounted kayak trolling motor

Search results

  1. Results from the WOW.Com Content Network
  2. Trolling motor - Wikipedia

    en.wikipedia.org/wiki/Trolling_motor

    A trolling motor is a self-contained marine propulsion unit that includes an electric motor, propeller and control system, and is affixed to an angler's boat, either at the bow or stern. A gasoline-powered outboard used in trolling , if it is not the vessel's primary source of propulsion, may also be referred to as a trolling motor.

  3. Rear-engine, rear-wheel-drive layout - Wikipedia

    en.wikipedia.org/wiki/Rear-engine,_rear-wheel...

    To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...

  4. Trolling (fishing) - Wikipedia

    en.wikipedia.org/wiki/Trolling_(fishing)

    Trolling plates are also used with larger motors to slow the boat to the desired speed, although some anglers experience mixed results with plates. [citation needed] Trolling can be effective at surprisingly low speeds. Kayaks fitted with a deck-mounted bracket for holding a rod can be paddled to troll effectively for salmon. [18]

  5. Pusher configuration - Wikipedia

    en.wikipedia.org/wiki/Pusher_configuration

    1871 Planophore A Farman MF.11, showing the classic Farman configuration with engine between tail booms Buhl A-1 Autogyro, the first pusher autogyro The post-WWII Convair B-36 was unusual in its size, era, number of engines, and combining both propeller and jet propulsion, with six radial piston and four jet engines Typical of many UAVs, the General Atomics MQ-9 Reaper has a propeller at the ...

  6. Rear mid-engine, rear-wheel-drive layout - Wikipedia

    en.wikipedia.org/wiki/Rear_mid-engine,_rear...

    RMR layout; the engine is located in front of the rear axle. Rear Mid-engine transversely-mounted / Rear-wheel drive. In automotive design, an RMR, or rear mid-engine, rear-wheel-drive layout is one in which the rear wheels are driven by an engine placed with its center of gravity in front of the rear axle, and thus right behind the passenger compartment.

  7. List of pusher aircraft by configuration and date - Wikipedia

    en.wikipedia.org/wiki/List_of_pusher_aircraft_by...

    Fauvel AV.45 1960 1 seat motor glider, unk no. built; Rohr 2-175 1974 2 seat roadable aircraft, 1 built [67] [68] Cascade Kasperwing I-80 1976 UL 1 seater; Pterodactyl Ascender 1979 1 seat ultralight, 1396 built; Mitchell U2 Superwing 1980 1 seat ultralight; Facet Opal, 1988, 1 seat, experimental flying wing, 1 built [69]

  8. Category:Rear-engined vehicles - Wikipedia

    en.wikipedia.org/wiki/Category:Rear-engined_vehicles

    Rear-engined, front-wheel-drive vehicles (2 P) Pages in category "Rear-engined vehicles" The following 195 pages are in this category, out of 195 total.

  9. Skeg - Wikipedia

    en.wikipedia.org/wiki/Skeg

    In the kayak, the amount of exposure of the skeg to the water, and also its effect on the position of the boat's centre of lateral resistance (CLR), is freely adjustable by the crew. The adjustment varies the degree to which the wind affects the boat – that is, the amount of lateral movement the wind can cause by impacting the upper parts of ...

  1. Ads

    related to: rear mounted kayak trolling motor