Search results
Results from the WOW.Com Content Network
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [1] Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various ...
At the furnace, cool air passes into the furnace, usually through an air filter, through the blower, then through the heat exchanger of the furnace, whence it is blown throughout the building. One major advantage of this type of system is that it also enables easy installation of central air conditioning , simply by adding a cooling coil at the ...
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.
A Morse code light is light in which appearances of light of two clearly different durations (dots and dashes) are grouped to represent a character or characters in the Morse Code. For example, "Mo(A)" is a light in which in each period light is shown for a short period (dot) followed by a long period (dash), the Morse Code for "A".
An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.
Compared to water, air masses have a lower heat capacity. This means that they cool down faster, but they also raise the room temperature in a short time. [8] [9] Low thermal inertia allows literally in a few minutes to heat different in volume buildings. [10] At the same time, all the heat goes only to heat the rooms. [11]
The importance of valve leakage depends on what the valve is controlling. For example, a dripping tap is less significant than a leak from a six-inch pipe carrying high-pressure radioactive steam. In the United States, the American National Standards Institute specifies six different leakage classes, with "leakage" defined in terms of the full ...