Search results
Results from the WOW.Com Content Network
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
MIL-STD 461, "Requirements for the control of electromagnetic interference characteristics of subsystems and equipment" [18] MIL-STD-464, "Electromagnetic Environmental Effects Requirements for Systems" [19] MIL-STD-498, on software development and documentation [20] MIL-STD-499, on Engineering Management (System Engineering)
A United States data item description (DID) is a completed document defining the data deliverables required of a United States Department of Defense contractor. [1] A DID specifically defines the data content, format, and intended use of the data with a primary objective of achieving standardization objectives by the U.S. Department of Defense.
MIL-STD-498. RTCA DO-178. DOD-STD-2167A (Department of Defense Standard 2167A), titled "Defense Systems Software Development", was a United States defense standard, published on February 29, 1988, which updated the less well known DOD-STD-2167 published 4 June 1985. This document established "uniform requirements for the software development ...
Data requirements can also be identified in the contract via special contract clauses (e.g., DFARS), which define special data provisions such as rights in data, warranty, etc. SOW guidance of MIL-HDBK-245D describes the desired relationship: "Work requirements should be specified in the SOW, and all data requirements for delivery, format, and ...
EIA-649 was adopted for use by the United States Department of Defense (DoD) in February 1999, [3] [13] [14] replacing Mil-Std-973. [15] Even though the US DoD has 649 called out as a guidance document in their contracts, EIA-649 is currently used in both commercial and governmental environments since the authors of EIA-649 tried not to express ...
It is preferred that articles in this category be listed by publishing identifier (MIL-STD-####) for consistency. Pages in category "Military of the United States standards" The following 46 pages are in this category, out of 46 total.
TADIL-J refers to the system of standardized J-series messages which are known by NATO as Link 16.These are defined by U.S. military standard (MIL-STD) 6016. It is used by the U.S. Navy, U.S. Army, U.S. Marine Corps, U.S. Air Force, U.S. Coast Guard, the NSA, several NATO countries, and Japan as part of the Multi-Tactical Data Link Network, a Tactical Data Link.