enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Centerlock wheel - Wikipedia

   en.wikipedia.org/wiki/Centerlock_wheel

   These consist of a shaft at the hub, with an external screw thread, a straight external spline section and a tapered interface at the hub base. The wheel centers have internal splines and a matching taper to align and center them on the hub. The wheels are fastened to the hub by means of a winged, threaded nut, called a "knock-off" or "spinner."

3. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate. A roller bearing between the axle hub and axle shaft ensures easy rotation of the non-drive wheels. On the axle side, it is mounted to the holding bracket from the chassis; on the disc side, the wheel is mounted to the bolts of the WHA ...

4. Locking hubs - Wikipedia

   en.wikipedia.org/wiki/Locking_hubs

   The hub is a component where the wheel is directly mounted to, and is outside the axle. The benefits of unlocking hubs for normal road use are mainly found in increased fuel efficiency . When the front hubs are locked, even if no power is sent to the front axle (by means of a transfer case ), the turning of the wheels will still spin the front ...

5. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   Wheel hub with disc brake and 5 wheel studs. Wheel studs are the threaded fasteners that hold on the wheels of many automobiles. They are semi-permanently mounted directly to the vehicle hub, usually through the brake drum or brake disk. Lug nuts are fastened onto the wheel stud to secure the wheel. When a wheel is removed for tire changes etc ...

6. Leading wheel - Wikipedia

   en.wikipedia.org/wiki/Leading_wheel

   The leading wheel or leading axle or pilot wheel of a steam locomotive is an unpowered wheel or axle located in front of the driving wheels. The axle or axles of the leading wheels are normally located on a leading truck. Leading wheels are used to help the locomotive negotiate curves and to support the front portion of the boiler.

7. Spoke - Wikipedia

   en.wikipedia.org/wiki/Spoke

   For an asymmetric wheel such as a front wheel with disc brake or a rear wheel with chain derailleur, the value of d is different for the left and right sides. a is the angle between (1) the radius to a nipple hole in the rim to which a spoke is attached, and, (2) the radius to the flange hole holding the spoke.

8. Pilot-operated relief valve - Wikipedia

   en.wikipedia.org/wiki/Pilot-operated_relief_valve

   The pressure from the pilot tube to the dome is routed through the actual control pilot valve. There are many designs but the control pilot is essentially a conventional PRV with the special job of controlling pressure to the main valve dome. The pressure at which the control pilot relieves is the functional set pressure of the PORV.

9. Mallet locomotive - Wikipedia

   en.wikipedia.org/wiki/Mallet_locomotive

   This came to be understood as a "Mallet" locomotive: an articulated locomotive in which the rear set of driving wheels were fixed in the main frame of the locomotive; an articulated truck carrying a second set of driving wheels; and compounding in which the high-pressure cylinders drove the axles on the main frame and the articulated axles were ...