Search results
Results from the WOW.Com Content Network
Conversely, a phase reversal or phase inversion implies a 180-degree phase shift. [ 2 ] When the phase difference φ ( t ) {\displaystyle \varphi (t)} is a quarter of turn (a right angle, +90° = π/2 or −90° = 270° = −π/2 = 3π/2 ), sinusoidal signals are sometimes said to be in quadrature , e.g., in-phase and quadrature components of a ...
Phase-fired control (PFC), also called phase cutting or phase-angle control, is a method for power limiting, applied to AC voltages. [1] It works by modulating a thyristor , SCR , triac , thyratron , or other such gated diode -like devices into and out of conduction at a predetermined phase angle of the applied waveform.
A common dual dimmer module used in stage lighting A dimmer. A dimmer is a device connected to a light fixture and used to lower the brightness of the light.By changing the voltage waveform applied to the lamp, it is possible to lower the intensity of the light output.
In physics, dephasing is a mechanism that recovers classical behaviour from a quantum system. It refers to the ways in which coherence caused by perturbation decays over time, and the system returns to the state before perturbation. It is an important effect in molecular and atomic spectroscopy, and in the condensed matter physics of mesoscopic ...
As a practical matter, many 0-10 V dimming control inputs can be operated by replacing the variable control resistor with an electronic switch. When the switch is on, the control voltage is near 0 and the light is fully dim. When the switch is off, the control voltage is maximum and the light is fully bright.
The phase velocity of a wave is the rate at which the wave propagates in any medium. This is the velocity at which the phase of any one frequency component of the wave travels. For such a component, any given phase of the wave (for example, the crest) will appear to travel at the phase velocity.
The phase space of a physical system is the set of all possible physical states of the system when described by a given parameterization. Each possible state corresponds uniquely to a point in the phase space. For mechanical systems, the phase space usually consists of all possible values of the position and momentum parameters.
Angle notation can easily describe leading and lagging current: . [1] In this equation, the value of theta is the important factor for leading and lagging current. As mentioned in the introduction above, leading or lagging current represents a time shift between the current and voltage sine curves, which is represented by the angle by which the curve is ahead or behind of where it would be ...