Search results
Results from the WOW.Com Content Network
The XGC88000 crawler crane, unlike the majority of crawler cranes, comes in two sections. The primary section consists of the crane itself, which boasts a maximum boom length of 144 meters, a maximum total length of 173 meters (including the counterweight radius), a maximum height (when fully erect) of 108 meters, a lifting capacity ranging between 3,600 and 4,000 tons [10] [11] [12] (although ...
The crane frame is supported on a gantry system with equalized beams and wheels that run on the gantry rail, usually perpendicular to the trolley travel direction. These cranes come in all sizes, and some can move very heavy loads, particularly the extremely large examples used in shipyards or industrial installations.
Some new cranes have a 120-tonne load capacity, enabling them to lift up to four 20-foot (6.1 m) or two 40-foot (12 m) containers. Cranes capable of lifting six 20-foot containers have also been designed. Post-Panamax cranes weigh approximately 800–900 tonnes, while the newer-generation super-post-Panamax cranes can weigh 1,600–2,000 tonnes.
The nesting territory of common cranes is variable and is based on the local habitat. It can range in size from variously 2 to 500 ha (4.9 to 1,235.5 acres). In common with sandhill cranes (and no other crane species), common cranes "paint" their bodies with mud or decaying vegetation, apparently in order to blend into their nesting environment.
Taisun, the world's strongest gantry crane, at Yantai Raffles Shipyard, Yantai, China. Full gantry cranes (where the load remains beneath the gantry structure, supported from a beam) are well suited to lifting massive objects such as ships' engines, as the entire structure can resist the torque created by the load, and counterweights are generally not required.
An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap. A hoist, the lifting component of a crane, travels along the bridge.
In 1959 crane expert R.H.Neal, hydraulics specialist F.Taylor, and design director Bob Lester, integrated all three and modernized cranes. The Coles Hydra Speedcrane appeared in 1962, further modified with the 10-ton fully telescopic hydraulic boom in 1966, followed in 1968 by the 30-ton "Husky" military versions with four-wheel drive .
Prior to the cranes for Sleipnir, the largest bearings Huisman had used for tub-mounted cranes were only 12 m (39 ft) in diameter. [5] The crane house is secured to the foundation using 1,100 bolts 82 mm (3.2 in) in diameter, each weighing more than 40 kg (88 lb), and held in place by nuts.