Search results
Results from the WOW.Com Content Network
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
Device interfaces where one bus transfers data via another will be limited to the throughput of the slowest interface, at best. For instance, SATA revision 3.0 ( 6 Gbit/s ) controllers on one PCI Express 2.0 ( 5 Gbit/s ) channel will be limited to the 5 Gbit/s rate and have to employ more channels to get around this problem.
Bus (computing), a communication system that transfers data between different components in a computer or between different computers Memory bus, a bus between the computer and the memory; PCI bus, a bus between motherboard and peripherals that uses the Peripheral Component Interconnect standard
Analog camcorders commonly use a 3.5 mm four-contact TRRS connector to carry composite video and stereo audio. Jack appears identical to more common three-contact stereo audio-only 3.5 mm TRS connector. DisplayPort: DisplayPort (DP) was designed to replace VGA, DVI, and FPD-Link and standardized by VESA. [2]
ARINC 429, [1] the "Mark 33 Digital Information Transfer System (DITS)," is the ARINC technical standard for the predominant avionics data bus used on most higher-end commercial and transport aircraft. [2] It defines the physical and electrical interfaces of a two-wire data bus and a data protocol to support an aircraft's avionics local area ...
USB 1.0, 1.1, and 2.0 use two wires for power (V BUS and GND) and two wires for one differential signal of serial data. [7] Mini and micro connectors have their GND connections moved from pin #4 to pin #5, while their pin #4 serves as an ID pin to electrically differentiate A and B plugs when connecting to the AB receptacles of On-The-Go devices.
ARINC 429 utilizes a unidirectional bus with a single transmitter and up to twenty receivers. A data word consists of 32 bits communicated over a twisted pair cable using the bipolar return-to-zero modulation. There are two speeds of transmission: high speed operates at 100 kbit/s and low speed operates at 12.5 kbit/s.
[4] There is an architectural limit of 256 devices per channel, and initially a limitation of 200 feet (61 m), later extended to 400 feet (120 m), between the mainframe and the control unit. [5] Bus and Tag channels handle data rates up to 4.5 MB per second. [6] Only one device can transfer data at a time. [5]