Ads
related to: fluorescent light lens covers 1800ceiling replacement panels
Search results
Results from the WOW.Com Content Network
A fluorescent lamp, or fluorescent tube, is a low-pressure mercury-vapor gas-discharge lamp that uses fluorescence to produce visible light. An electric current in the gas excites mercury vapor, to produce ultraviolet and make a phosphor coating in the lamp glow.
Cross section of a typical fluorescent lamp with and without a reflector. Some lamps have an internal opaque reflector. Coverage of the reflector ranges from 120° to 310° of the lamp's circumference. Reflector lamps are used when light is only desired to be emitted in a single direction, or when an application requires the maximum amount of ...
A broken fluorescent tube will release its mercury content. Safe cleanup of broken fluorescent bulbs differs from cleanup of conventional broken glass or incandescent bulbs, avoiding the use of vacuum cleaners, in favour of sticky tape to recover small particles, and ensuring that fans and air conditioning are turned off.
Artcraft Fluorescent Lighting Corporation [2] was an American mass manufacturer of fluorescent lighting fixtures from the time of the public introduction of the fluorescent lamp at the 1939 World's Fair. Artcraft was first to announce and start mass manufacturing of a liner showcase striplight fixture and slimline ballast in 1946. [3] [4]
A color scroller, color changer, or "scroller" is a lighting accessory used to change color gels on stage lighting instruments without the need of a person to be in the vicinity of the light. [5] It is attached in the gel frame holder on the outside of a lighting instrument, immediately in front of lens assembly.
Light fixtures which have earned Energy Star combine quality design with the high energy efficiency. [32] To qualify for an Energy Star rating light fixtures must: [33] Uses 1/4 the energy of traditional lighting; Reduced energy bills and bulb replacement. Lifetime is at least 10,000 hours; Even light distribution
Circular and U-shaped lamps were devised to reduce the length of fluorescent light fixtures. The first fluorescent light bulb and fixture were displayed to the general public at the 1939 New York World's Fair. The spiral CFL was invented in 1976 by Edward E. Hammer, an engineer with General Electric, [7] in response to the 1973 oil crisis. [8]
For example, the dichroic prism assembly used in some cameras requires two dielectric coatings, one long-wavelength pass filter reflecting light below 500 nm (to separate the blue component of the light), and one short-pass filter to reflect red light, above 600 nm wavelength. The remaining transmitted light is the green component.
Ads
related to: fluorescent light lens covers 1800ceiling replacement panels