Search results
Results from the WOW.Com Content Network
Any converter box converts the digital signal for the current digital sub-channel to an analog signal (at the reduced screen resolution of the analog standard), outputs that signal onto analog channel 3 or 4 (set by the user to avoid any conflict with local over-the-air channels) and sends that signal to the analog tuner on the TV. With a box ...
A cable converter box or television converter box is an electronic tuning device that transposes/converts channels from a cable television service to an analog RF signal on a single channel, usually VHF channel 3 or 4, or to a different output for digital televisions such as HDMI.
In an analog television broadcast, the brightness, colors and sound are represented by amplitude, phase and frequency of an analog signal. Analog signals vary over a continuous range of possible values which means that electronic noise and interference may be introduced. Thus with analog, a moderately weak signal becomes snowy and subject to ...
A digital TV converter box. A digital television adapter (DTA), commonly known as a converter box, DTV converter , or decoder box, is a television tuner that receives a digital television (DTV) transmission, and converts the digital signal into an analog signal that can be received and displayed on an analog television set.
A typical modern set-top box, along with its remote control - pictured here a digital terrestrial TV receiver by TEAC. A set-top box (STB), also known as a cable box, receiver, or simply box, and historically television decoder or a converter, [1] is an information appliance device that generally contains a TV tuner input and displays output to a television set, turning the source signal into ...
A cable from the jack in the wall is attached to the input of the box, and an output cable from the box is attached to the television, usually the RF-IN or composite input on older TVs. Since the set-top box only decodes the single channel that is being watched, each television in the house requires a separate box.
It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...
It is an involved process because the existing analogue television receivers owned by viewers cannot receive digital broadcasts; viewers must either purchase new digital TVs, or digital converter boxes which have a digital tuner and change the digital signal to an analog signal or some other form of a digital signal (i.e. HDMI) which can be ...