enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Automatic faucet - Wikipedia

   en.wikipedia.org/wiki/Automatic_faucet

   A hands-free faucet in Japan. An automatic faucet or tap (also hands-free faucet, touchless faucet, electronic faucet, motion-sensing faucet, sensor faucet, or infrared faucet) is a faucet equipped with a proximity sensor and mechanism that opens its valve to allow water to flow in response to the presence of a user's hands in close proximity.

3. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [10] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

4. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   When an aerator is added to the faucet (or fluid stream), there is a region of high pressure created behind the aerator. Because of the higher pressure behind the aerator and the low pressure in front of it (outside the faucet), due to Bernoulli's principle there is an increase in velocity of the fluid flow.

5. Moen Incorporated - Wikipedia

   en.wikipedia.org/wiki/Moen_Incorporated

   Most Moen kitchen, washbasin, and bathtub/shower faucets are of the single-handle design, and almost all have used the same basic water-controlling cartridge from the 1960s until 2010. Known as the Moen 1225, it is a plastic (older versions were brass) cylinder approximately 4 inches long by 3/4 inches in diameter.

6. EPA WaterSense - Wikipedia

   en.wikipedia.org/wiki/EPA_WaterSense

   Using the efficiency standards established by EPACT92 as a baseline, the EPA instituted the following flow-rate guidelines for WaterSense: toilets must be manufactured with a maximum flush volume of 1.28 gpf; showerheads must have a maximum flow-rate of 2.0 gpm at 80 psi; and bathroom faucets must be manufactured with a low-flow volume rate of ...

7. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Its rate is independent of the viscosity or temperature of the fluid or gas in the pipe, and depends only weakly on the supply pressure, so that flow rate is stable at a given setting. At intermediate flow settings the pressure at the valve restriction drops nearly to zero from the Venturi effect ; in water taps, this causes the water to boil ...