Search results
Results from the WOW.Com Content Network
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...
G5.3 – 5.3 mm (0.20866 in) pin spacing GU5.3, GX5.3, GY5.3, GZ5.3 – same as G5.3 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G6.35 – 6.35 mm (0.25 in)spacing GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0. ...
Low voltage lamps use the GU5.3 and similar bi-pin bases, whereas mains voltage lamps use the same caps as normal mains tungsten filament lamps, or a special GU10/GZ10 base. The GU10/GZ10 bases are shaped to prevent dichroic reflector lamps being used in luminaires intended for aluminised reflector lamps, which could cause overheating of the ...
A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs.
The bulb is inserted and removed with straight in or out force, without turning as with a bayonet mount or Edison screw, on certain bi-pin light sockets. For true wedges, compression is the force that holds the bulb in, while others use simple friction , or snap into a socket with spring -loaded electrical contacts that "grab" the corners or ...
Compact fluorescent mogul-base bulbs are also available, as are adaptors to allow medium-base bulbs to be used in mogul sockets. There are usually two three-way switches near the top of the floor lamp to operate the bulbs. One controls the three-way center bulb, and the other turns on one, two, or all three (or four) of the peripheral bulbs.
G9 bipin halogen light bulbs are used in downlights and spotlights and have a similar physical profile to the more common 12 Volt halogen bulbs, but operate at mains voltage. This means they do not require a transformer to step the voltage down, and consequently can be dimmed using standard dimmers .