Search results
Results from the WOW.Com Content Network
The physical hardware communications link (physical layer) is not defined by SCPI. [5] While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer ...
4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.
Python 3.0 was released on 3 December 2008, with some new semantics and changed syntax. At least every Python release since (now unsupported) 3.5 has added some syntax to the language, and a few later releases have dropped outdated modules, or changed semantics, at least in a minor way.
A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [ 2 ] [ 3 ] A typical multimeter can measure voltage , resistance , and current , [ 4 ] in which case can be used as a voltmeter , ohmmeter , and ammeter .
CircuitPython [5] is an open-source derivative of the MicroPython programming language targeted toward students and beginners. Development of CircuitPython is supported by Adafruit Industries. It is a software implementation of the Python 3 programming language, written in C. [3] It has been ported to run on several modern microcontrollers.
The AVR Dragon provides in-system serial programming, high-voltage serial programming and parallel programming, as well as JTAG or debugWIRE emulation for parts with 32 KB of program memory or less. ATMEL changed the debugging feature of AVR Dragon with the latest firmware of AVR Studio 4 – AVR Studio 5 and now it supports devices over 32 KB ...
JAM / STAPL ("Standard Test and Programming Language") [1] is an Altera-developed standard for JTAG in-circuit programming of programmable logic devices (PLDs). [2] It is defined by JEDEC standard JESD-71. [2] STAPL defines a standard .jam file format which supports in-system programmability or configuration of programmable devices.
In late 2004, the std project was renamed to py, std.utest became py.test, and the py library was separated from PyPy. In November 2010, pytest 2.0.0 was released as a package separate from py. It was still called py.test until August 2016, but following the release of pytest 3.0.0 the recommended command line entry point became pytest. [3]