Search results
Results from the WOW.Com Content Network
TRIAC. For other uses, see Triac. A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor[ 1 ]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark. TRIACs are a subset of thyristors (analogous to a relay ...
The thyristor is a four-layered, three-terminal semiconductor device, with each layer consisting of alternating N-type or P-type material, for example P-N-P-N. The main terminals, labelled anode and cathode, are across all four layers. The control terminal, called the gate, is attached to p-type material near the cathode.
A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current -controlling device. The name "silicon controlled rectifier" is General Electric 's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell ...
Phase-fired control (PFC) is often used to control the amount of voltage, current or power that a power supply feeds to its load. It does this to create an average value at its output. If the supply has a DC output, its time base is of no importance in deciding when to pulse the supply on or off, as the value that will be pulsed on and off is ...
A crowbar circuit is an electrical circuit used for preventing an overvoltage or surge condition of a power supply unit from damaging the circuits attached to the power supply. It operates by putting a short circuit or low resistance path across the voltage output (V o), like dropping a crowbar across the output terminals of the power supply.
The DIAC (diode for alternating current) is a diode that conducts electrical current only after its breakover voltage, V BO, has been reached momentarily. Three, four, and five layer structures may be used. [1] Behavior is similar to the voltage breakdown of a triac without a gate terminal. When breakdown occurs, internal positive feedback ...
A thyratron is a type of gas-filled tube used as a high-power electrical switch and controlled rectifier. Thyratrons can handle much greater currents than similar hard-vacuum tubes. Electron multiplication occurs when the gas becomes ionized, producing a phenomenon known as a Townsend discharge. Gases used include mercury vapor, xenon, neon ...
Thyristor: The thyristor is a family of three-terminal devices that include SCRs, GTOs, and MCT. For most of the devices, a gate pulse turns the device on. The device turns off when the anode voltage falls below a value (relative to the cathode) determined by the device characteristics. When off, it is considered a reverse voltage blocking ...