enow.com Web Search

  1. Ads

    related to: difference between water and moisture tester

Search results

  1. Results from the WOW.Com Content Network
  2. Moisture meter - Wikipedia

    en.wikipedia.org/wiki/Moisture_meter

    The difference between radial and tangential shrinkage also varies from species to species. Woods with a low ratio of tangential to radial shrinkage, such as teak and mahogany, are less prone to distortion due to changes in moisture content than woods with a high ratio, such as eastern white pine and certain species of oak.

  3. Moisture vapor transmission rate - Wikipedia

    en.wikipedia.org/wiki/Moisture_vapor...

    Moisture vapor transmission rate (MVTR), also water vapor transmission rate (WVTR), is a measure of the passage of water vapor through a substance. It is a measure of the permeability for vapor barriers .

  4. Moisture analysis - Wikipedia

    en.wikipedia.org/wiki/Moisture_analysis

    Moisture dew point is the temperature at which moisture condenses out of a gas. This parameter is inherently related to the moisture content, which defines the amount of water molecules as a fraction of the total. Both can be used as a measure of the amount of moisture in a gas and one can be calculated from the other fairly accurately.

  5. Breathability - Wikipedia

    en.wikipedia.org/wiki/Breathability

    The B-1 variant of test method puts membrane in direct contact with water while B-2 variant adds an ePTFE film between the water and the fabric. While B-2 is a good test, it eliminates the effect of fabric when in direct contact with water.

  6. Karl Fischer titration - Wikipedia

    en.wikipedia.org/wiki/Karl_Fischer_titration

    The popularity of the Karl Fischer titration (henceforth referred to as KF) is due in large part to several practical advantages that it holds over other methods of moisture determination, such as accuracy, speed and selectivity. KF is selective for water, because the titration reaction itself consumes water.

  7. Atterberg limits - Wikipedia

    en.wikipedia.org/wiki/Atterberg_limits

    The moisture content at which it takes 25 drops of the cup to cause the groove to close over a distance of 12.7 millimetres (0.50 in) is defined as the liquid limit. The test is normally run at several moisture contents, and the moisture content which requires 25 blows to close the groove is interpolated from the test results.

  1. Ads

    related to: difference between water and moisture tester