Ad
related to: sae j1962 data link connector 2018 mustang gt for sale cargurus
Search results
Results from the WOW.Com Content Network
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
They are both required to be accessed through a standardized data link connector defined by SAE J1962. Heavy duty vehicles (greater than 14,000 lb or 6,400 kg) made after 2010, [1] for sale in the US are allowed to support OBD-II diagnostics through SAE standard J1939-13 (a round diagnostic connector) according to CARB in title 13 CCR 1971.1 ...
EMD+ was used on model year 2010-2012 California and Federal petrol-engined vehicles with a gross vehicle weight rating of over 14,000 lb (6,400 kg), it added the ability to monitor nitrogen oxide catalyst performance. EMD and EMD+ are similar to OBD-I in logic but use the same SAE J1962 data connector and CAN bus as OBD-II systems. [8]
ALDL 12 pins connector - front view. Assembly Line Diagnostic Link, Assembly Line Data Link, or ALDL is a proprietary on-board diagnostics system developed by General Motors before the standardization of OBD-2. It was previously called Assembly Line Communications Link or ALCL. The two terms are used interchangeably.
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
The plug for SAE J560 is physically identical to the connector ISO 1185. The difference is that J560 indicates that the voltage must be 12 V and that wire areas shall be larger due to the higher currents needed when using 12 V compared to 24 V. Some of the pins in the connector have also a slightly different function.
TADIL-J refers to the system of standardized J-series messages which are known by NATO as Link 16.These are defined by U.S. military standard (MIL-STD) 6016. It is used by the U.S. Navy, U.S. Army, U.S. Marine Corps, U.S. Air Force, U.S. Coast Guard, the NSA, several NATO countries, and Japan as part of the Multi-Tactical Data Link Network, a Tactical Data Link.
It has since been adopted as the recommended connector in most countries worldwide, including New Zealand. [6] When passing AC, the maximum power of the Mennekes connector is 43 kW. [7] The IEC 62196 Type 1 connector (codified under SAE J1772) is the corresponding standard for single-phase AC charging in the United States, Canada, and South ...
Ad
related to: sae j1962 data link connector 2018 mustang gt for sale cargurus