Search results
Results from the WOW.Com Content Network
Tempered hardboard is a hardboard that has been coated with a thin film of linseed oil and then baked; this gives it more water resistance, impact resistance, hardness, rigidity and tensile strength. An earlier tempering process involved immersing the board in linseed oil or tung oil until it was 5 to 6 percent saturated, and heating to 170 °C ...
The most common dimension is 1.2 by 2.4 metres (3 ft 11 in × 7 ft 10 in) or the slightly larger imperial dimension of 4 feet × 8 feet. Plies vary in thickness from 1.4 mm to 4.3 mm. The number of plies—which is always odd—depends on the thickness and grade of the sheet. Roofing can use the thinner 16-millimetre (5 ⁄ 8 in) plywood.
The pressing cycle operates in stages, with the mat thickness being first compressed to around 1.5 times the finished board thickness, then compressed further in stages and held for a short period. This gives a board profile with zones of increased density, thus mechanical strength, near the two faces of the board and a less dense core. [9]
Headquartered in Tampa, Florida, Masonite employs more than 10,000 people worldwide, and is the only door manufacturer to serve both the residential and architectural markets. [citation needed] Today, many of Masonite’s interior and exterior doors are conceptualized at the Masonite Innovation Center (MIC) located in West Chicago, Illinois ...
Masonite board Back side of a masonite board Isorel, c. 1920 Quartrboard, [1] Masonite Corporation, c. 1930. Masonite, also called Quartboard or pressboard, [2] is a type of engineered wood made of steam-cooked and pressure-molded wood or paper fibers.
Perforated hardboard and similar systems are made of a variety of materials, each of which has different characteristics that affect the range of possible uses. Standard perforated hardboard is made of wood fibers, usually with the addition of resin , and tempered by coating with a thin layer of linseed oil and baking at a high temperature to ...
Sheet sizes vary slightly from manufacturer to manufacturer but generally they range between 2400 – 3000 mm in length and 900 –1200mm in width (600 & 450 mm increments). This manufactured size minimizes on-site wastage as residential floor, wall and roof structures lay structural members at 450 or 600mm centres.
The mat is placed in a thermal press to compress the flakes and bond them by heat activation and curing of the resin that has been coated on the flakes. Individual panels are then cut from the mats into finished sizes. Most of the world's OSB is made in the United States and Canada in large production facilities.