Search results
Results from the WOW.Com Content Network
Headsets of this type are often referred to by the Dia-Compe (now Cane Creek) registered trademark "Aheadset", [2] [3] and are manufactured under license. Like a traditional headset, it uses two sets of bearings and bearing cups. Unlike a threaded headset, a threadless headset does not have a threaded top headset race or use a threaded steerer ...
The quill stem requires the threaded steerer tube of the fork to extend up through the headset but not protrude beyond it. The quill stem fits down into the inside of the top of steerer tube and is held in place by either a wedge-shaped nut and bolt or a cone-shaped expander nut and bolt. [ 2 ]
In 2008, Campagnolo introduced 11-speed drivetrains with Super Record, Record, and Chorus groupsets. Campagnolo has released an electronic version of its drivetrain. [7] In April 2018 Campagnolo launched 12-speed Record and Super Record groupsets, [8] and in 2020, the company launched Campagnolo Ekar, a 13-speed groupset aimed at gravel riders. [9]
The TNCA connector is a variant of the TNC connector specified in MIL-STD-348 [1] designed to provide an air gap in the dielectric region between the male and female connectors.
Thread is an IPv6-based, low-power mesh networking technology for Internet of things (IoT) products. [1] The Thread protocol specification is available at no cost; however, this requires agreement and continued adherence to an end-user license agreement (EULA), which states "Membership in Thread Group is necessary to implement, practice, and ship Thread technology and Thread Group specifications."
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
Optical fiber connectors are used to join optical fibers where a connect/disconnect capability is required. Due to the polishing and tuning procedures that may be incorporated into optical connector manufacturing, connectors are often assembled onto optical fiber in a supplier's manufacturing facility.
1600 ohm magnetic headset. The early earphones used with wireless-era crystal sets had moving iron drivers that worked in a way similar to the horn loudspeakers of the period. Each earpiece contained a permanent magnet about which was a coil of wire which formed a second electromagnet. Both magnetic poles were close to a steel diaphragm of the ...