Search results
Results from the WOW.Com Content Network
Sump pumps are used where basement flooding may otherwise happen, and to solve dampness where the water table is near or above the foundation of a structure. Sump pumps send water away from a location to any place where it is no longer problematic, such as a municipal storm drain, a dry well, or simply an open-air site downhill from the building (sometimes called "pumping to daylight").
A vacuum ejector, or simply ejector, or aspirator, is a type of vacuum pump, which produces vacuum by means of the Venturi effect.. In an ejector, a working fluid (liquid or gaseous) flows through a jet nozzle into a tube that first narrows and then expands in cross-sectional area.
The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...
Typically, water is channeled from a high-level reservoir to a low-level reservoir, through turbine generators that generate electricity. This is done when the station is required to generate power. During low-demand periods, such as overnight, the generators are reversed to become pumps that move the water back up to the top reservoir.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
The S type pump is useful for removing water from a well or container. Shallow well pumps are those in which the jet assembly is attached directly to the main pump and are limited to a depth of approximately 5-8m to prevent cavitation. Deep well pumps are those in which the jet is located at the bottom of the well. The maximum depth for deep ...
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom. [12]