enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2-inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8-inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming (S&D) bits, whose sets run from 9 ⁄ 16-inch (14 mm) to 1 + 1 ⁄ 2-inch (38 mm) drill body ...

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

4. Grinding wheel - Wikipedia

   en.wikipedia.org/wiki/Grinding_wheel

   Grinding wheels are self-sharpening to a small degree; for optimal use they may be dressed and trued by the use of wheel or grinding dressers. Dressing the wheel refers to removing the current layer of abrasive, so that a fresh and sharp surface is exposed to the work surface. Trueing the wheel makes the grinding surface parallel to the ...

5. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...

7. Cutting tool (machining) - Wikipedia

   en.wikipedia.org/wiki/Cutting_tool_(machining)

   3 angles: clearance angle, wedge angle, rake (chipping) angle; Δr; length and orientation of the bevel; Cutting edge profile with parameters. One of the most important cutting edge parameters is the K factor. It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall.