Search results
Results from the WOW.Com Content Network
D-head (clipped head) nail – a common or box nail with part of the head removed for some pneumatic nail guns; Double-ended nail – a rare type of nail with points on both ends and the "head" in the middle for joining boards together. See this patent. Similar to a dowel nail but with a head on the shank.
A drawing pin has two basic components: the head, often made of plastic, metal or wood, and the body, usually made of steel or brass. The head is wide to distribute the force of pushing the pin in, allowing only the hands to be used. Many head designs exist: flat, domed, spherical, cylindrical and a variety of novelty heads such as hearts or ...
A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed.
The nail, as shown in the patent document. The HurriQuake nail was a construction nail designed by Ed Sutt for Bostitch, a division of Stanley Works, and patented in 2004.. The nail was designed primarily to provide more structural integrity for a building, especially against the forces of hurricanes and earthqua
PureNails 10-Piece Professional Manicure and Pedicure Kit. Master the art of precision with the seven pieces included in this kit, which buffs everything from nail beds to calluses.
Nail files. A nail file is a tool that can be used to gently grind down and shape the edges of nails. They are often used in manicures and pedicures after the nail has been trimmed using appropriate nail clippers. Nail files may either be emery boards, ceramic, glass, crystal, plain metal files or metal files coated with corundum.
[1] [2] Other names for the tool include adjustable square, combo square, and sliding square. The most common head is the standard head, which is used as a square for marking and testing 90° and 45° angles. [3] The other common types of head are the protractor head, and the centre finder head. [4]
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.