Search results
Results from the WOW.Com Content Network
This simplified arrangement has several advantages, including a shorter ground distance between the ends. For example, a dipole antenna for the 80 meter band requires a ground length of about 140 feet (43 m) from end to end. An inverted vee with a 40-foot (12 m) apex elevation requires only 115 feet (35 m).
The nominal "80 meter" band begins at 3.5 MHz (85.7 m wavelength) and goes up to 4.0 MHz (74.9 m wavelength).The upper part of the band, mostly used for voice, is often referred to as 75 meters, since in Region 2, the wavelengths in that section are between 80–75 meters (adjacent to or overlapping a shortwave broadcast band called by the same name: "75 m").
In particular for low frequencies this antenna form is interesting. [4] The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground .
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
In antenna terms, each of the conductors making up the antenna is known as an element. [9] To calculate the net result, NEC breaks the antenna's elements into a number of sampled points, called segments. It uses simple calculations based on the diameter of the conductor and the wavelength of the signal to determine the induced voltage and ...
Tests done by J.S. Belrose (1994) [7] showed that though the conventional T²FD length is close to a full-size 80 meter (3.5–4.0 MHz) antenna, the antenna starts to suffer serious signal loss both on transmit and receive below 10 MHz (30 m), with the 80 meter band signals −10 dB down (90% power loss) from a reference dipole at 10 MHz.
Radio direction finding equipment for eighty meters, an HF band, is relatively easy to design and inexpensive to build. Bearings taken on eighty meters can be very accurate. Competitors on an eighty-meter course must use bearings to determine the locations of the transmitters and choose the fastest route through the terrain to visit them.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...