enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shaft (golf) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(golf)

   The shaft is roughly .58 inch/14.7 millimeters in diameter near the grip and between 35 and 48 inches/89–115 cm in length. Shafts weigh between 45 and 150 grams depending on the material and length. Graphite shafts are woven from carbon fiber and are generally lighter in weight than steel shafts. Graphite shafts became popular among amateurs ...

3. Golf club - Wikipedia

   en.wikipedia.org/wiki/Golf_club

   The shaft is roughly 0.5 inches (13 mm) in diameter near the grip and from 34 to 48 inches (86 to 122 cm) in length. Shafts weigh from 45 to 150 grams (1.6 to 5.3 oz), depending on the material and length. [2] Shafts are quantified in a number of different ways. The most common is the shaft flex.

4. Long drive - Wikipedia

   en.wikipedia.org/wiki/Long_drive

   Until the recent club length limitation rules, the shafts were much longer than a normal 45 in (114.3 cm) shaft, sometimes exceeding 55 in (139.7 cm). In 2005, a 50 in (127.0 cm) limitation was introduced (measured vertically). Long drive shafts differ from standard shafts.

5. Wood (golf) - Wikipedia

   en.wikipedia.org/wiki/Wood_(golf)

   The shaft length in woods varies from about 40–48 inches (101.6–121.9 cm), with the current standard length for the driver being 45 in (114.3 cm), formerly 43.5 in (110.5 cm). Graphite shafts are usually preferred for woods due to their light weight, which enables users to generate higher clubhead speeds and thus greater distance.

6. Iron (golf) - Wikipedia

   en.wikipedia.org/wiki/Iron_(golf)

   The shaft length of an iron decreases as the iron's number increases; therefore the iron number is inversely proportionate to its length. This reduced length means that a clubhead of the same mass traveling at the same angular velocity (degrees per second, as swung by a golfer) has lower momentum because the clubhead's speed is slower.

7. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   The standard lengths of the shafts are 5 m, 6 m and 7 m. Usually 1m to 5m is used. Stresses. The following stresses are induced in the shafts.