Search results
Results from the WOW.Com Content Network
The Voith Schneider propeller was originally a design for a hydro-electric turbine. [2] Its Austrian inventor, Ernst Schneider, had a chance meeting on a train with a manager at Voith's subsidiary St. Pölten works; this led to the turbine being investigated by Voith's engineers, who discovered that although it was no more efficient than other water turbines, Schneider's design worked well as ...
Aldila manufactures OEM shafts for many of the major golf club manufacturers including Callaway, TaylorMade and Ping, in addition to a range of Aldila branded consumer shafts. Production of shafts takes place outside of the United States, Vietnam , and China, while prepreg production occurs in Poway.
A single shaft runs below the rollers running the length of the conveyor. On the shaft are a series of spools, one spool for each roller. An elastic polyurethane o-ring belt runs from a spool on the powered shaft to each roller. When the shaft is powered, the o-ring belt acts as a chain between the spool and the roller making the roller rotate.
Before shaft alignment can be done, the foundations for the driver and the driven piece must be designed and installed correctly. [citation needed]Flexible couplings are designed to allow a driver (e.g., electric motor, engine, turbine, hydraulic motor) to be connected to the driven equipment.
The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.
For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Adjacent images in the section below show a transmission input shaft with male splines and a clutch plate with mating female splines in the center hub, where the smooth tip of the axle would be supported in a pilot bearing in ...
In machine tools, a spindle is a rotating axis of the machine, which often has a shaft at its heart. The shaft itself is called a spindle, but also, in shop-floor practice, the word often is used metonymically to refer to the entire rotary unit, including not only the shaft itself, but its bearings and anything attached to it (chuck, etc.).
OpenVSP displays a graphical user interface upon launch, built with FLTK.A workspace window and a "Geometry Browser" window open. The workspace is where the model is displayed while the Geometry Browser lists individual components in the workspace, such as fuselage and wings.