Search results
Results from the WOW.Com Content Network
Consider a quality characteristic with a target of 100.00 μm and upper and lower specification limits of 106.00 μm and 94.00 μm, respectively. If, after carefully monitoring the process for a while, it appears that the process is out of control and producing output unpredictably (as depicted in the run chart below), one can't meaningfully estimate its mean and standard deviation.
Values near or below zero indicate processes operating off target (^ far from T) or with high variation. Fixing values for minimum "acceptable" process capability targets is a matter of personal opinion, and what consensus exists varies by industry, facility, and the process under consideration.
The ability of a process to meet specifications can be expressed as a single number using a process capability index or it can be assessed using control charts. Either case requires running the process to obtain enough measurable output so that engineering is confident that the process is stable and so that the process mean and variability can ...
To this plot is added a line at the average value, x and lines at the UCL and LCL values. On a separate graph, the calculated ranges MR i are plotted. A line is added for the average value, MR and second line is plotted for the range upper control limit (UCL r).
An acceptable quality level is a test and/or inspection standard that prescribes the range of the number of defective components that is considered acceptable when random sampling those components during an inspection. The defects found during an electronic or electrical test, or during a physical (mechanical) inspection, are sometimes ...
A USAF 1951 resolution chart in PDF format is provided by Yoshihiko Takinami. This chart should be printed such that the side of the square of the 1st element of the group -2 should be 10 mm long. USAF 1951 Resolution Target Further explanations and examples; Koren 2003: Norman Koren's updated resolution chart better suited for computer analysis
Symbol used to represent in situ permeability tests in geotechnical drawings. In fluid mechanics, materials science and Earth sciences, the permeability of porous media (often, a rock or soil) is a measure of the ability for fluids (gas or liquid) to flow through the media; it is commonly symbolized as k.
A go/no-go test is a two-step verification process that uses two boundary conditions, or a binary classification.The test is passed only when the go condition has been met and also the no-go condition has failed.