Search results
Results from the WOW.Com Content Network
Accent (or spot) microphone placement. Often, the tonal and ambient qualities will sound very different between a distant- and close-miked pickup. Under certain circumstances, it's difficult to obtain a naturally recorded balance when mixing the two together.
When concealing the mic is important, such as with film production, a smaller housing may be desirable. Sanken's CUB-01 boundary microphone has a 32 mm diameter and 12 mm height, which makes it easier to hide in TV and film field shooting and easier to reposition or temporarily mount in locations (e.g. taping it onto the inside ceiling of a car).
The placement can be done with three separate microphone stands or using one or more bars. In contrast to the ORTF stereo technique , the Decca Tree size is not fixed and may vary considerably; distances between the two back microphones are seen between 0.6 and 1.2 m; the front microphone is set proportionally and can be mounted slightly lower ...
With this technique is the angle between the microphone axes α = ± 55° = 110° and the distance between the cardioid microphones (microphone basis) is in this case a = 17 cm and gives a total recording angle of 96°. The choice between one and the other depends on the recording angle of the microphone system and not on the distance to and ...
This can be particularly useful when placing microphones on a drum stand when the microphone stands must compete for space with things like cymbal stands. Boom arms are offered both in fixed length and adjustable (telescoping) lengths. Another handy device for adjusting microphone placement is a flexible goose neck tube. Made of a spiral-wound ...
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
This means the microphone must be positioned precisely equidistant from the two speakers if 'comb-filter' effects (alternate peaks and dips in the measured room response at that point) are to be avoided. Positioning is best done by moving the mic from side to side for maximum response on a 1 kHz tone, then a 3 kHz tone, then a 10 kHz tone.
ORTF setup. The ORTF stereo technique, also known as side-other-side, is a microphone technique used to record stereo sound.It was devised around 1960 at the now-defunct Office de Radiodiffusion Télévision Française (ORTF).