Ad
related to: hankison condensate drain valve
Search results
Results from the WOW.Com Content Network
Air admittance valves (AAVs, or commonly referred to in the UK as Durgo valves and in the US as Studor vents and Sure-Vent®) are negative-pressure-activated, one-way mechanical valves, used in a plumbing or drainage venting system to eliminate the need for conventional pipe venting and roof penetrations.
Note also the 30' discharge valve and actuator to the left of the pump. - Lakeview Pumping Station, Clarendon and Montrose Avenues, Chicago, Cook County, IL} A condensate pump is a specific type of pump used to pump the condensate produced in an HVAC (heating or cooling), refrigeration, condensing boiler furnace, or steam system. [1]
Older and larger dryers still use R-22 and R-404a refrigerants. The goal of having two heat exchangers is that the cold outgoing air cools down the hot incoming air and reduces the size of compressor required. At the same time the increase in the temperature of outgoing air prevents re-condensation. Some manufacturers produce "cycling dryers".
Steam traps are nothing more than automatic valves. They open, close or modulate automatically. [1] The three important functions of steam traps are: Discharge condensate as soon as it is formed (unless it is desirable to use the sensible heat of the liquid condensate) Have a negligible steam consumption (i.e. be energy efficient)
Water on the roof is usually drained by a special flexible hose or other special drain line system that runs from drain-sumps on the roof, through the stored liquid to a drain valve on the shell at the base of the tank. A hose is the shortest quickest route, Other drain systems are available both rigid and semi-rigid.
It is theoretically possible that, when both valves are faulty, backflow could occur, should the reverse flow rate exceed the capacity of the relief valve. Because certain combinations of check valve failure and/or system backpressure cause the relief valve to discharge, the device must be mounted in a location where the drain will not become ...
For premium support please call: 800-290-4726 more ways to reach us
Isolation valves in a flare, relief or vent system must ensure that a flow path is always available to the flare or vent. These valves are secured in the open position (LO). Drain valves that connect a high pressure system to a low pressure drain system are locked in the closed position (LC) to prevent potential over-pressurisation of the drain ...
Ad
related to: hankison condensate drain valve