enow.com Web Search

  1. Ad

    related to: water heater overflow pipe requirements for residential construction near me

Search results

  1. Results from the WOW.Com Content Network
  2. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    According to the International Residential Code 2003, an air gap length must meet the requirements of being two times the effective inner diameter of the pipe (2×D) in order to be sufficient. [2] A standard widely use in the United States is: A112.1.2 Air Gaps in Plumbing Systems (For Plumbing Fixtures and Water-Connected Receptors)

  3. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  4. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Maintaining the water seal is critical to trap operation; traps might dry out, and poor venting can suction or blow water out of the traps. This is usually avoided by venting the drain pipes downstream of the trap; by being vented to the atmosphere outside the building, the drain lines never operate at a pressure much higher or lower than ...

  5. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.

  6. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

  7. Backflow - Wikipedia

    en.wikipedia.org/wiki/Backflow

    Backflow is a term in plumbing for an unwanted flow of water in the reverse direction. [1] It can be a serious health risk for the contamination of potable water supplies with foul water . In the most obvious case, a toilet flush cistern and its water supply must be isolated from the toilet bowl.

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    Old water pipe, remnant of the Machine de Marly near Versailles, France. Lead was the favoured material for water pipes for many centuries because its malleability made it practical to work into the desired shape. Such use was so common that the word "plumbing" derives from plumbum, the Latin word for lead.

  1. Ad

    related to: water heater overflow pipe requirements for residential construction near me