Search results
Results from the WOW.Com Content Network
Z tables use at least three different conventions: Cumulative from mean gives a probability that a statistic is between 0 (mean) and Z. Example: Prob(0 ≤ Z ≤ 0.69) = 0.2549. Cumulative gives a probability that a statistic is less than Z. This equates to the area of the distribution below Z. Example: Prob(Z ≤ 0.69) = 0.7549. Complementary ...
Normally, however, only a subset is available, and the variance calculated from this is called the sample variance. The variance calculated from a sample is considered an estimate of the full population variance. There are multiple ways to calculate an estimate of the population variance, as discussed in the section below.
The term "Z-test" is often used to refer specifically to the one-sample location test comparing the mean of a set of measurements to a given constant when the sample variance is known. For example, if the observed data X 1 , ..., X n are (i) independent, (ii) have a common mean μ, and (iii) have a common variance σ 2 , then the sample average ...
This follows from the fact that the variance and mean are independent of the ordering of x. Scale invariance: c v (x) = c v (αx) where α is a real number. [22] Population independence – If {x,x} is the list x appended to itself, then c v ({x,x}) = c v (x). This follows from the fact that the variance and mean both obey this principle.
This algorithm can easily be adapted to compute the variance of a finite population: simply divide by n instead of n − 1 on the last line.. Because SumSq and (Sum×Sum)/n can be very similar numbers, cancellation can lead to the precision of the result to be much less than the inherent precision of the floating-point arithmetic used to perform the computation.
Confidence intervals for mean and variance of the normal distribution (also here) Confidence interval for the parameters of a simple linear regression; Confidence interval for the difference of means (based on data from a normal distributions, without assuming equal variances) Comparing the Proportions of Two Binomials using z-test
The sum of squared deviations needed to calculate sample variance (before deciding whether to divide by n or n − 1) is most easily calculated as = From the two derived expectations above the expected value of this sum is
which is an unbiased estimator of the variance of the mean in terms of the observed sample variance and known quantities. If the autocorrelations are identically zero, this expression reduces to the well-known result for the variance of the mean for independent data. The effect of the expectation operator in these expressions is that the ...