Search results
Results from the WOW.Com Content Network
Pin and hanger assembly. A pin and hanger assembly is used to connect two plate girders of a bridge.These assemblies are used to provide an expansion joint in the bridge. One beam (the anchor span) is set on a pier with a short section cantilevered out toward the next pier.
A expansion joint, or movement joint, is an assembly designed to hold parts together while safely absorbing temperature-induced expansion and contraction of building materials. They are commonly found between sections of buildings , bridges , sidewalks , railway tracks , piping systems , ships , and other structures.
Note that if the bridge has an expansion joint (a discontinuity), the sections of the bridge would be considered separate (by the definition of a continuous bridge) for the purposes of this ranking. The Yoshima Bridge is an example of this. It consists of two continuous-truss sections that together have five total spans.
The omission of the expansion joint removes a pathway for the penetration of chloride-bearing road salts to the bridge's sub-structure. In the United Kingdom there is a presumption that most new short to medium length bridges will be of the integral type. [citation needed] An early example of an integral bridge is masonry arch bridge.
A slide plate is a linear bearing that may be part of the expansion joints of bridges, high temperature horizontal ducts of water-tube boilers and other mechanical or structural engineering applications. In each case one plate is fixed and the other slides on top as expansion or contraction occurs.
A continuous truss bridge is a truss bridge that extends without hinges or joints across three or more supports. A continuous truss bridge may use less material than a series of simple trusses because a continuous truss distributes live loads across all the spans; in a series of simple trusses, each truss must be capable of supporting the ...
An expansion bearing on the Queen Elizabeth II Metro Bridge. A bridge bearing is a component of a bridge which typically provides a resting surface between bridge piers and the bridge deck . The purpose of a bearing is to allow controlled movement and thereby reduce the stresses involved.
Examples of the latter are tripods, hiking poles, or similar telescoping device. The clamping mechanism is based on a cam, a set screw, or a similar locking mechanism. Slip joints can also be non-telescoping, such as the joints on some older wooden surveyor's levelling rods. These use a joint that keeps the sections offset from each other but ...