enow.com Web Search

  1. Ads

    related to: 2 in 1 toilet and basin storage reservoir tank

Search results

  1. Results from the WOW.Com Content Network
  2. Rainwater tank - Wikipedia

    en.wikipedia.org/wiki/Rainwater_tank

    A rainwater catchment or collection (also known as "rainwater harvesting") system can yield 1,000 litres (260 US gal) of water from 1 cm (0.4 in) of rain on a 100 m 2 (1,100 sq ft) roof. Rainwater tanks are installed to make use of rain water for later use, reduce mains water use for economic or environmental reasons, and aid self-sufficiency.

  3. Rainwater harvesting - Wikipedia

    en.wikipedia.org/wiki/Rainwater_harvesting

    configuration of domestic rainwater harvesting system in Uganda. [1]Rainwater harvesting (RWH) is the collection and storage of rain, rather than allowing it to run off.. Rainwater is collected from a roof-like surface and redirected to a tank, cistern, deep pit (well, shaft, or borehole), aquifer, or a reservoir with percolation, so that it seeps down and restores the ground w

  4. San Francisco Fire Department Auxiliary Water Supply System

    en.wikipedia.org/wiki/San_Francisco_Fire...

    Twin Peaks Reservoir, at near-empty level. The Twin Peaks Reservoir is the backbone of the AWSS system and is located at the top of San Francisco's Twin Peaks hilltop. It is made up of a 10.5-million-U.S.-gallon (40-million-liter) storage reservoir made out of 6-inch-thick (150 mm) reinforced-concrete slabs. Two 750-US-gallon-per-minute (2,800 ...

  5. Tank cascade system - Wikipedia

    en.wikipedia.org/wiki/Tank_cascade_system

    The cascade network draws from or serves to a variety of reservoirs: pahala wewa (village tank), kulu wewa (forest tanks), pin wewa (temple tanks), olagam wewa (supplementary tanks), ilaha wewa (storage tanks), et al. [11] [3] Tanks are edged with earthen embankments (or bund) called wekandas with integrated water gates called kuto sorowwas ...

  6. Water-sensitive urban design - Wikipedia

    en.wikipedia.org/wiki/Water-sensitive_urban_design

    Water Sensitive Urban Design with Green Infrastructure in the bottom right corner.. Water-sensitive urban design (WSUD) is a land planning and engineering design approach which integrates the urban water cycle, including stormwater, groundwater, and wastewater management and water supply, into urban design to minimise environmental degradation and improve aesthetic and recreational appeal. [1]

  7. Water storage - Wikipedia

    en.wikipedia.org/wiki/Water_storage

    Fill the tank completely with clean water, close the lid and leave to stand for 24 hours. [16] Flush: After the chlorine solution has sat in the tank for 24 hours, flush out/empty the storage tank. Do not drain the tank into a septic system or adjacent surface water body.

  8. Water tank - Wikipedia

    en.wikipedia.org/wiki/Water_tank

    An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...

  9. Flush toilet - Wikipedia

    en.wikipedia.org/wiki/Flush_toilet

    If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...

  1. Ads

    related to: 2 in 1 toilet and basin storage reservoir tank