Search results
Results from the WOW.Com Content Network
The Cheng cycle is a simplified form of combined cycle where the steam turbine is eliminated by injecting steam directly into the combustion turbine. This has been used since the mid 1970s and allows recovery of waste heat with less total complexity, but at the loss of the additional power and redundancy of a true combined cycle system.
Cogeneration or combined heat and power (CHP) is the use of a heat engine [1] or power station to generate electricity and useful heat at the same time. Cogeneration is a more efficient use of fuel or heat, because otherwise-wasted heat from electricity generation is put to some productive use.
Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [ 1 ] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).
A simple cycle gas turbine achieves energy conversion efficiencies from 20 to 35%. [5] Typical coal-based power plants operating at steam pressures of 170 bar and 570 °C run at efficiency of 35 to 38%, [6] with state-of-the-art fossil fuel plants at 46% efficiency. [7] Combined-cycle systems can reach higher values.
A cogeneration plant in Berlin Gas generates over 20% of world electricity Share of electricity production from gas. A gas-fired power plant, sometimes referred to as gas-fired power station, natural gas power plant, or methane gas power plant, is a thermal power station that burns natural gas to generate electricity.
With proper material selection, an OTSG can be run dry, meaning the hot exhaust gases can pass over the tubes with no water flowing inside the tubes. This eliminates the need for a bypass stack and exhaust gas diverter system which is required to operate a combustion turbine with a drum-type HRSG out of service. [2]
Combined cycle plants have both a gas turbine fired by natural gas, and a steam boiler and steam turbine which use the hot exhaust gas from the gas turbine to produce electricity. This greatly increases the overall efficiency of the plant, and many new baseload power plants are combined cycle plants fired by natural gas.
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...