Search results
Results from the WOW.Com Content Network
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...
Signed binary angle measurement. Black is traditional degrees representation, green is a BAM as a decimal number and red is hexadecimal 32-bit BAM. In this figure the 32-bit binary integers are interpreted as signed binary fixed-point values with scaling factor 2 −31, representing fractions between −1.0 (inclusive) and +1.0 (exclusive).
Decimal degrees (DD) is a notation for expressing latitude and longitude geographic coordinates as decimal fractions of a degree. DD are used in many geographic information systems (GIS), web mapping applications such as OpenStreetMap, and GPS devices. Decimal degrees are an alternative to using degrees-minutes-seconds notation. As with ...
For repeating patterns that begin immediately after the decimal point, the result of the conversion is the fraction with the pattern as a numerator, and the same number of nines as a denominator. For example: 0. 5 = 5/9 0. 62 = 62/99 0. 264 = 264/999 0. 6291 = 6291/9999
Some modern building codes require that the millimetre be used in preference to the centimetre, because "use of centimetres leads to extensive usage of decimal points and confusion". [10] These prefixes are also commonly used to create metric units corresponding to older conventional units, for example hectares and hectopascals .
Additional precision can be provided using decimal fractions of an arcsecond. Maritime charts are marked in degrees and decimal minutes to facilitate measurement; 1 minute of latitude is 1 nautical mile. The example above would be given as 40° 11.25′ (commonly written as 11′25 or 11′.25). [13]
There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction, rather than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and ...
A unit of measurement that applies to money is called a unit of account in economics and unit of measure in accounting. [5] This is normally a currency issued by a country or a fraction thereof; for instance, the US dollar and US cent (1 ⁄ 100 of a dollar), or the euro and euro cent.