Search results
Results from the WOW.Com Content Network
Under the 1300 Composition of Yards and Perches, one of the statutes of uncertain date that was notionally in force until the 1824 Weights and Measures Act, "3 barly cornes dry and rounde" [2] [3] were to serve as the basis for the inch and thence the larger units of feet, yards, perches and thus of the acre, an important unit of area.
historical definitions of the units and their derivatives used in old measurements; e.g., international foot vs. US survey foot. For some purposes, conversions from one system of units to another are needed to be exact, without increasing or decreasing the precision of the expressed quantity.
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.
Volume was measured in ngogn (equal to 1000 cubic potrzebies), mass in blintz (equal to the mass of 1 ngogn of halva, which is "a form of pie [with] a specific gravity of 3.1416 and a specific heat of .31416"), and time in seven named units (decimal powers of the average earth rotation, equal to 1 "clarke").
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
The definition of units of weight above a pound differed between the customary and the imperial system - the imperial system employed the stone of 14 pounds, the hundredweight of 8 stone [Note 6] and the ton of 2240 pounds (20 hundredweight), while the customary system of units did not employ the stone but has a hundredweight of 100 pounds and ...
In the late 13th century, the modern foot of 304.8 mm was introduced, equal to exactly 10 ⁄ 11 Anglo-Saxon foot. Cubit: 457.2 mm: From fingertips to elbow, 18 inches. Yard: 0.914 m: 3 feet = 36 inches, the practical base unit, defined as the length of the prototype bar held by the Crown or Exchequer. Ell: 1.143 m
The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in). The Greek foot ( πούς , pous ) had a length of 1 / 600 of a stadion , [ 12 ] one stadion being about 181.2 m (594 ft); [ 13 ] therefore a foot was, at the time, about 302 mm (11.9 in).