Search results
Results from the WOW.Com Content Network
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6; Cadillac HT4100/4.5/4.9 L V8; Isuzu all 3.2 and 3.5L DOHC V6
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
By the mid-1990s, the 4T60-E was the transmission of choice in nearly every front-wheel drive GM vehicle with the exception of compacts. A heavy-duty 4T60-E HD was produced in 1996 for the supercharged GM 3800 engine and reused in mid 2005 to 2009 with an LS4 5.3 liter V8 in four different models the Buick Lacrosse Super, Chevrolet Impala SS ...
The New Venture Gear 3500, commonly called NV3500, is a 5-speed overdrive manual transmission manufactured by New Venture Gear and used by GM and Dodge in compact and full-size light trucks. It can be identified by its two-piece aluminum case with integrated bell housing and top-mounted tower shifter.
Starting around 1925 engine blocks and cylinder heads were now developed at each brand but were cast at Saginaw Metal Casting Operations. [3] In the mid-1960s, there were 8 separate families of GM V8 engines on sale in the USA. [4] [1] By the 1970s, GM began to see problems with their approach.
The 4.8L and the 5.3L are smaller truck versions of the LS1 and were designed to replace the 305 and the 350 in trucks. The 4.8L and 5.3L engines share the same Gen III LS-series engine block and heads (upper end) and therefore, most parts interchange freely between these engines and other variants in the LS family.
The Synchro-mesh 465 or SM465 is a heavy-duty, four-speed manual transmission built by General Motors for use in light and medium duty trucks from 1968 to 1991 at the factory in Muncie, Indiana; it was designed to replace the somewhat similar Muncie SM420 transmission, which had been in production since just after World War II.
An updated 4L60E, the 4L65E (RPO M32), was phased in the 2001 model year when coupled behind the 6.0 Vortec. Five-pinion front and rear planetaries, along with an additional 3/4 clutch allowing 7 clutches in the input housing and induction hardened input shaft assembly, were improved to withstand up to 380 ft⋅lb (520 N⋅m) of torque.