Ads
related to: oval shape boat thru hull scupper drain pan with hole in the middle poletemu.com has been visited by 1M+ users in the past month
boatoutfitters.com has been visited by 10K+ users in the past month
north40.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Scupper: 8. hole (with grille cover), 9. pipe, 10. outlet. There are two main kinds of scuppers: Ships have scuppers at deck level, to allow for ocean or rainwater drain-off. [1] Buildings with railed rooftops may have scuppers to let rainwater drain instead of pooling within the railing. Scuppers can also be placed in a parapet, for the same ...
Limber holes perforate the wall of the box at the floor of each chamber. Dorade boxes operate on the principle that air can pass relatively freely through the chambers, yet rain or sea wash will be trapped in successive chambers and drain out of the small holes in the sides of the box. The principle can be applied to other forms.
A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors. Limber holes are created in ...
Water that does not drain off the side of the deck or through a hole in the hull, which it would typically do via a scupper, instead drains down into the ship into the bilge. This water may be from rough seas, rain, leaks in the hull or stuffing box, or other interior spillage. The collected water must be pumped out to prevent the bilge from ...
The bottom is flat in a river junk with no keel (similar to a sampan), so that the boat relies on a daggerboard, [16] leeboard or very large rudder to prevent the boat from slipping sideways in the water. [17] The internal bulkheads are characteristic of junks, providing interior compartments and strengthening the ship.
Oval in shape and very similar to half a walnut shell, the coracle has a keel-less flat bottom to evenly spread the load across the structure and to reduce the required depth of water; often to only a few inches. This structure helps to make the boat more maneuverable and less likely to snag when used on narrow and/or shallow slow-running ...
Ads
related to: oval shape boat thru hull scupper drain pan with hole in the middle poletemu.com has been visited by 1M+ users in the past month
boatoutfitters.com has been visited by 10K+ users in the past month
north40.com has been visited by 10K+ users in the past month