Ads
related to: pentastar 3.6 rocker arm cost
Search results
Results from the WOW.Com Content Network
The Pentastar engines are made in three different factories: Dundee Engine Plant, Trenton Engine Plant and Saltillo South Engine Plant. [1] The Pentastar engine was introduced at the 2009 New York Auto Show. [2] [3] The engine design allows the use of E85 or 87 octane fuel and features dual variable valve timing.
Continuously commanded by engine control unit, the valve rocker arm switches between high-lift and low-lift profiles on the camshaft, actuated by an oil control valve through a two-feed stationary hydraulic lash adjuster, allowing for either 4.0 or 10.5 mm lift. [2]
In 2007 Chrysler announced a new 822,000-square-foot (76,400 m 2) engine plant to produce the Pentastar V6 engine.It has the annual capacity of 440,000 engines. [3] The new facility is LEED Gold certified, with features such as Zero-Waste-to-Landfill processes, the use of native grasses and trees on the property, higher performance insulation and more efficient manufacturing processes ...
The latest revision of the Buick 3.8-litre V6 engine was fitted to the VR Commodore, featuring rolling-element bearings in the valve rocker arms and increased compression ratios. [92] These changes combined to deliver an increase in power to 130 kW (174 hp) and further improvement in noise, vibration, and harshness levels. [89]
The SOHC V6 has been replaced by the Chrysler Pentastar engine. There are three major variants of this basic design: the 3.5 L, 3.2 L, and 4.0 L. Additionally, ...
The Chrysler 300 continues a tradition of full-sized, front-engine, rear-wheel drive, V8-powered luxury sedans the company has offered, starting in the 1940s with the Chrysler Saratoga and Chrysler New Yorker, followed by the Chrysler Windsor, Chrysler Newport, and the Chrysler Cordoba, with the last rear wheel drive sedan, the Chrysler Fifth Avenue that ended production in 1989.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The Grand Cherokee's origins date back to 1983 when American Motors Corporation (AMC) was designing a successor to the Jeep Cherokee. [3] Three outside (non-AMC) designers—Larry Shinoda, Alain Clenet, and Giorgetto Giugiaro—were also under contract with AMC to create and build a clay model of the Cherokee XJ replacement, then known as the "XJC" project. [4]
Ads
related to: pentastar 3.6 rocker arm cost