enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Uniform Tire Quality Grading - Wikipedia

   en.wikipedia.org/wiki/Uniform_Tire_Quality_Grading

   These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]

3. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...

4. Cold inflation pressure - Wikipedia

   en.wikipedia.org/wiki/Cold_inflation_pressure

   A 2001 NHTSA study found that 40% of passenger cars have at least one tire under-inflated by 0.4 bars (6 psi) or more. [1] The number one cause of tire failure was determined to be under-inflation. Drivers are encouraged to make sure their tires are adequately inflated at all times.

5. Tire sizes and ratings: What do letters and numbers mean?

   www.aol.com/news/tire-sizes-ratings-letters...

   For premium support please call: 800-290-4726 more ways to reach us

6. Tyre label - Wikipedia

   en.wikipedia.org/wiki/Tyre_label

   Rolling resistance is the main key factor in measuring the energy efficiency of a tyre and has direct influence on the fuel consumption of a vehicle. A set of tyres of the green class "A" compared to a "G" class can reduce fuel consumption by 9% [3] of a passenger car; even more for trucks.

7. Tire uniformity - Wikipedia

   en.wikipedia.org/wiki/Tire_uniformity

   Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...