Search results
Results from the WOW.Com Content Network
A typical example of the use of a common-emitter amplifier is shown in Figure 3. Figure 3: Single-ended npn common-emitter amplifier with emitter degeneration. The AC-coupled circuit acts as a level-shifter amplifier. Here, the base–emitter voltage drop is assumed to be 0.65 volts.
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
Diagram from Widlar's original patent. A Widlar current source is a modification of the basic two-transistor current mirror that incorporates an emitter degeneration resistor for only the output transistor, enabling the current source to generate low currents using only moderate resistor values.
In bipolar transistors, as the junction temperature increases the V be drop (voltage drop from base to emitter) decreases. In the two previous circuits, a decrease in V be will cause an increase in voltage across the emitter resistor, which in turn will cause an increase in collector current drawn through the load. The end result is that the ...
As a result, the common emitter resistor R E acts nearly as a current source. The output voltages at the collector load resistors R C1 and R C3 are shifted and buffered to the inverting and non-inverting outputs by the emitter followers T4 and T5 (shaded blue). The output emitter resistors R E4 and R E5 do not exist in all versions of ECL. In ...
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.
The current replication ratio may be altered by scaling the transistors, or by the insertion of degeneration resistors in series with the emitters, as was the case with the LH0002. To ensure correct mirroring, T1 and T2 (as well as the opposite pair T3 and T4) must be placed on the die in close proximity or, in case of discrete devices, mounted ...
If Q 1 and Q 2 are matched, that is, have substantially the same device properties, and if the mirror output voltage is chosen so the collector-base voltage of Q 2 is also zero, then the V BE-value set by Q 1 results in an emitter current in the matched Q 2 that is the same as the emitter current in Q 1 [citation needed].