Search results
Results from the WOW.Com Content Network
At this point the motor can be restarted. In such a unit, there are typically two potentiometers, one to vary the braking torque from the firing circuit and the other to vary the timer. These settings are balanced so that braking torque does not exceed rated motor torque, but also the braking time must be limited to prevent motor overheating ...
In embedded systems and control systems, watchdog timers are often used to activate fail-safe circuitry. When activated, the fail-safe circuitry forces all control outputs to safe states (e.g., turns off motors, heaters, and high-voltages) to prevent injuries and equipment damage while the fault persists. In a two-stage watchdog, the first ...
Using feedback, external time delay, and other sensory circuits, it is possible to build an electromechanical state machine using a cam timer. These are common in washing machines, where the cam timer runs in phases, but also stops and waits for external signals such as a fill level sensor, or a water heating temperature sensor.
The possibility of a single-event upset is suggested by the difference in votes being equivalent to a power of two, 2 12. [5] On October 7, 2008, Qantas Flight 72 at 37,000 feet, one of the plane's three air data inertial reference units had a failure, causing incorrect data to be sent to the plane's flight control systems. This caused pitch ...
This kind of electronic control is less common in piston-engined light fixed-wing aircraft and helicopters than in automobiles. This is due to the common configuration of a carbureted engine with a magneto ignition system that does not require electrical power generated by an alternator to run, which is considered a safety advantage. [12]
The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.
The control unit (CU) is a component of a computer's central processing unit (CPU) that directs the operation of the processor. A CU typically uses a binary decoder to convert coded instructions into timing and control signals that direct the operation of the other units (memory, arithmetic logic unit and input and output devices, etc.).
Time-triggered architecture (abbreviated as TTA), also known as a time-triggered system, is a computer system that executes one or more sets of tasks according to a predetermined and set task schedule. [1] Implementation of a TT system will typically involve use of a single interrupt that is linked to the periodic overflow of a timer.