Search results
Results from the WOW.Com Content Network
This drawing is to the scale of 1 pixel = 1 cm. Human figures, as drawn on the Pioneer 10 plaque, have been added for scale. According to the schematics on the plaque, the woman is 168 cm. Overall dimensions (6.7 m long and 2.5 m high) are taken from the OceanGate specification sheet: Titan 5-Person Submersible | 4,000 meters .
Because plans represent three-dimensional objects on a two-dimensional plane, the use of views or projections is crucial to the legibility of plans. Each projection is achieved by assuming a vantage point from which to see the place or object, and a type of projection. These projection types are:
Dimensions – the size of the object is captured in accepted units. Tolerances – the allowable variations for each dimension. Material – represents what the item is made of. Finish – specifies the surface quality of the item, functional or cosmetic. For example, a mass-marketed product usually requires a much higher surface quality than ...
Aside from the Orthographic, six standard principal views (Front; Right Side; Left Side; Top; Bottom; Rear), descriptive geometry strives to yield four basic solution views: the true length of a line (i.e., full size, not foreshortened), the point view (end view) of a line, the true shape of a plane (i.e., full size to scale, or not ...
The length of the line on the linear scale is equal to the distance represented on the earth multiplied by the map or chart's scale. In most projections, scale varies with latitude, so on small scale maps, covering large areas and a wide range of latitudes, the linear scale must show the scale for the range of latitudes covered by the map. One ...
A point in the plane may be represented in homogeneous coordinates by a triple (x, y, z) where x/z and y/z are the Cartesian coordinates of the point. [10] This introduces an "extra" coordinate since only two are needed to specify a point on the plane, but this system is useful in that it represents any point on the projective plane without the ...
An auxiliary view or pictorial, is an orthographic view that is projected into any plane other than one of the six primary views. [3] These views are typically used when an object has a surface in an oblique plane. By projecting into a plane parallel with the oblique surface, the true size and shape of the surface are shown.
A graphical or bar scale. A map would also usually give its scale numerically ("1:50,000", for instance, means that one cm on the map represents 50,000cm of real space, which is 500 meters) A bar scale with the nominal scale expressed as "1:600 000", meaning 1 cm on the map corresponds to 600,000 cm=6 km on the ground.