enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Wrench size. spanner (wrench) size and thread diameter of a hex nut. Width across flats is the distance between two parallel surfaces on the head of a screw or bolt, or a nut, mostly for torque transmission by positive locking. The term width across flats (AF) is used for the following forms: 2-socket = round material with two surfaces.

3. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth(BSW) is an imperial-unit-based screw threadstandard, devised and specified by Joseph Whitworthin 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper. History.

4. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...

5. The 7 Best Wrench Sets to Tackle DIY Projects - AOL

   www.aol.com/7-best-wrench-sets-tackle-173200483.html

   168-Piece Mechanic Tool and Socket Set. This comprehensive kit includes all the wrenches needed to tackle basic automotive maintenance tasks, including ratchet, combination, and Hex sets.

6. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Socket wrench. A socket wrench (or socket spanner) is a type of spanner (or wrench [ 1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt. [ 2] The most prevalent form is the ratcheting socket wrench, often informally called a ratchet.

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   A tap is used to cut or form the female portion of the mating pair (e.g. a nut ). A die is used to cut or form the male portion of the mating pair (e.g. a bolt ). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading . Both tools can be used to clean up a thread, which is ...