enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Door handle - Wikipedia

   en.wikipedia.org/wiki/Door_handle

   This is an accepted version of this page This is the latest accepted revision, reviewed on 20 December 2024. Device to open or close door Various examples of door handles throughout history A door handle or doorknob is a handle used to open or close a door. Door handles can be found on all types of doors including exterior doors of residential and commercial buildings, internal doors, cupboard ...

3. Mortise lock - Wikipedia

   en.wikipedia.org/wiki/Mortise_lock

   The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...

4. Door furniture - Wikipedia

   en.wikipedia.org/wiki/Door_furniture

   Bolt – A (nearly always) metal shaft attached by cleats or a specific form of bracket, that slides into the jamb to fasten a door. [2]: 89 Draw bolt - A form of crossbar latch where a bolt, held in place by metal bails, is slid to engage a bail fixed to a jamb or mating door. A small, typically knob, handle is affixed to the bolt to aid grip.

5. 118 Satisfying Before And After Restoration Pics That Prove ...

   www.aol.com/lifestyle/118-satisfying-restoration...

   The doors are about 130 years old, made from oak and are heritage protected. I am a carpenter and my job was to restore them, rebuild missing parts and treat the surface. I hope I did them justice.

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   A pentagon screw drive uses five-sided fastener heads, and the fastener is known as a penta screw or penta bolt. It is designed to be intrinsically incompatible with many tools. Since five is an odd number, it cannot be turned by open-end or adjustable wrenches, which have parallel faces (and thus require a fastener with an even number of sides).

7. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.