Ads
related to: boat hydraulic steering very stiff shaft system with pump and motor
Search results
Results from the WOW.Com Content Network
The rack takes the form of a double acting hydraulic ram, but is capable of taking over full steering function in the event of a hydraulic failure. During normal operation the rack and pinion merely provides a position indication to the steering control valve through the pinion shaft. The rack and pinion do the actual steering only in the ...
The increased low wind capabilities of optimized, modern devices enable downwind steering down to 1.3 m/s apparent wind and 1.5 kn of boat speed [8] [9] – properties that make an electronic steering device nearly redundant and enable crossing the doldrums under wind vane self-steering. An increasing number of long distance regatta sailors are ...
Outboard motor shaft lengths are standardized to fit 15-, 20- and 25-inch (38-, 51- and 64-centimeter) transoms. If the shaft is too long it will extend farther into the water than necessary creating drag, which will impair performance and fuel economy. If the shaft is too short, the motor will be prone to ventilation.
Schottel is a manufacturer of propulsion and steering systems for ships and offshore applications. The company founder Josef Becker invented the rudderpropeller, a z-drive, in 1950. Today the company develops and manufactures azimuth propulsion, maneuvering and steering systems. In 2014 the subsidiary Schottel Hydro was founded to bundle up the ...
Mechanical transmission, which connects a motor inside the ship to the outboard unit by gearing. The motor may be diesel or diesel-electric. Depending on the shaft arrangement, mechanical azimuth thrusters are divided into L-drive and Z-drive. An L-drive thruster has a vertical input shaft and a horizontal output shaft with one right-angle gear.
A later design of cross-drive transmission, the Allison X1100, was used in the 1970s experimental US MBT-70 and XM1 [3] tanks, then later adopted in the M1 Abrams.This adopts a different principle for the steering cross-coupling: instead of a hydro-dynamic torque converter, it uses a hydrostatic combination of a hydraulic pump and a hydraulic motor.
A Hydraulic Power Steering (HPS) uses hydraulic pressure supplied by an engine-driven pump to assist the motion of turning the steering wheel. Electric Power Steering (EPS) is more efficient than hydraulic power-steering, since the electric power-steering motor only needs to provide assistance when the steering wheel is turned, whereas the ...
A fluid coupling consists of three components, plus the hydraulic fluid: The housing, also known as the shell [5] (which must have an oil-tight seal around the drive shafts), contains the fluid and turbines. Two turbines (fanlike components): One connected to the input shaft; known as the pump or impeller, [5] or primary wheel input turbine. [5]
Ads
related to: boat hydraulic steering very stiff shaft system with pump and motor