Search results
Results from the WOW.Com Content Network
Direct memory access (DMA) is a feature of computer systems that allows certain hardware subsystems to access main system memory independently of the central processing unit (CPU). [ 1 ] Without DMA, when the CPU is using programmed input/output , it is typically fully occupied for the entire duration of the read or write operation, and is thus ...
The Word DMA (WDMA) interface is a method for transferring data between a computer (through an Advanced Technology Attachment (ATA) controller) and an ATA device; it was the fastest method until Ultra Direct Memory Access (UDMA) was implemented.
The Ultra DMA (Ultra Direct Memory Access, UDMA) modes are the fastest methods used to transfer data through the ATA hard disk interface, usually between a computer and an ATA device. UDMA succeeded Single / Multiword DMA as the interface of choice between ATA devices and the computer.
In computing, remote direct memory access (RDMA) is a direct memory access from the memory of one computer into that of another without involving either one's operating system. This permits high-throughput, low- latency networking, which is especially useful in massively parallel computer clusters .
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
Intel 8237A-5, used on the original IBM PC motherboard Pinout. Intel 8237 is a direct memory access (DMA) controller, a part of the MCS 85 microprocessor family. It enables data transfer between memory and the I/O with reduced load on the system's main processor by providing the memory with control signals and memory address information during the DMA transfer.
In computing, bus mastering is a feature supported by many bus architectures that enables a device connected to the bus to initiate direct memory access (DMA) transactions. It is also referred to as first-party DMA, in contrast with third-party DMA where a system DMA controller actually does the transfer.
Modern computers may have channels in the form of bus mastering peripheral devices, such as PCI direct memory access (DMA) devices. The rationale for these devices is the same as for the original channel controllers, namely off-loading transfer, interrupts, and context switching from the main CPU.