Search results
Results from the WOW.Com Content Network
Direct memory access (DMA) is a feature of computer systems that allows certain hardware subsystems to access main system memory independently of the central processing unit (CPU). [ 1 ] Without DMA, when the CPU is using programmed input/output , it is typically fully occupied for the entire duration of the read or write operation, and is thus ...
The Word DMA (WDMA) interface is a method for transferring data between a computer (through an Advanced Technology Attachment (ATA) controller) and an ATA device; it was the fastest method until Ultra Direct Memory Access (UDMA) was implemented.
In computing, remote direct memory access (RDMA) is a direct memory access from the memory of one computer into that of another without involving either one's operating system. This permits high-throughput, low- latency networking, which is especially useful in massively parallel computer clusters .
In computing, bus mastering is a feature supported by many bus architectures that enables a device connected to the bus to initiate direct memory access (DMA) transactions. It is also referred to as first-party DMA, in contrast with third-party DMA where a system DMA controller actually does the transfer.
The Ultra DMA (Ultra Direct Memory Access, UDMA) modes are the fastest methods used to transfer data through the ATA hard disk interface, usually between a computer and an ATA device. UDMA succeeded Single / Multiword DMA as the interface of choice between ATA devices and the computer.
In computing the SCSI RDMA Protocol (SRP) is a protocol that allows one computer to access SCSI devices attached to another computer via remote direct memory access (RDMA). [1] [2] The SRP protocol is also known as the SCSI Remote Protocol. The use of RDMA makes higher throughput and lower latency possible than what is generally available ...
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
The IBM PC took a more conventional approach, their adaptor card could support up to four drives; on the PC direct memory access (DMA) to the drives was performed using DMA channel 2 and IRQ 6. The diagram below shows a conventional floppy disk controller which communicates with the CPU via an Industry Standard Architecture (ISA) bus or similar ...