Ads
related to: tire width vs rolling resistance calculator
Search results
Results from the WOW.Com Content Network
Rolling resistance, sometimes called rolling friction or rolling drag, is the force resisting the motion when a body (such as a ball, tire, or wheel) rolls on a surface. It is mainly caused by non-elastic effects; that is, not all the energy needed for deformation (or movement) of the wheel, roadbed, etc., is recovered when the pressure is removed.
SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
Low rolling resistance tires are designed to reduce the energy loss as a tire rolls, decreasing the required rolling effort — and in the case of automotive applications, improving vehicle fuel efficiency as approximately 5–15% of the fuel consumed by a typical gas car may be used to overcome rolling resistance.
Rolling resistance is the resistance that occurs when a tyre rolls on a flat surface. The rolling resistance coefficients of motorcycle tyres are about 0.02. [ 1 ] It tends to increase with forward speed and decrease as inflation pressures increase.
In a non-scientific study (I looked at tires available from a national chain that fit my car), 85 percent of LRR tires had an “A” rating for traction, compared to 87 percent of Non-LRR tires.
Ads
related to: tire width vs rolling resistance calculator