Ads
related to: shaft size for bearing fitebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc.
This means that the smallest acceptable hole diameter will be 10.02 mm while the largest acceptable shaft diameter will be 10.01 mm, leaving an "allowance" of 0.01 mm. The minimum clearance between the hole and the shaft will then be 0.01 mm. This will occur when both the shaft and the hole are at maximum material condition.
Interference fits are commonly used with aircraft fasteners to improve the fatigue life of a joint. These fits, though applicable to shaft and hole assembly, are more often used for bearing-housing or bearing-shaft assembly. This is referred to as a 'press-in' mounting.
The maximum clearance of a fit is the difference between the upper bound of the orifice diameter and the lower bound of the shaft diameter. maximum clearance = maximum orifice diameter – minimum shaft diameter. The minimum clearance meanwhile is the difference between the lower bound of the orifice diameter and the upper bound of the shaft ...
Induction heating is a non contact heating process which uses the principle of electromagnetism induction to produce heat in a work-piece. In this case thermal expansion is used in a mechanical application to fit parts over one another, e.g. a bushing can be fitted over a shaft by making its inner diameter slightly smaller than the diameter of the shaft, then heating it until it fits over the ...
Ads
related to: shaft size for bearing fitebay.com has been visited by 1M+ users in the past month