Search results
Results from the WOW.Com Content Network
Windows 3.0 actually had several modes: "real mode", "standard mode" and "386-enhanced mode"; the latter required some of the virtualization features of the 80386 processor, and thus would not run on an 80286. Windows 3.1 removed support for real mode, and it was the first mainstream operating environment which required at least an 80286 processor.
When there are only a few addressing modes, the particular addressing mode required is usually encoded within the instruction code (e.g. IBM System/360 and successors, most RISC). But when there are many addressing modes, a specific field is often set aside in the instruction to specify the addressing mode.
To support old software, the processor starts up in "real mode", a mode in which it uses the segmented addressing model of the 8086. There is a small difference though: the resulting physical address is no longer truncated to 20 bits, so real mode pointers (but not 8086 pointers) can now refer to addresses between 100000 16 and 10FFEF 16 .
The x86 processors support five modes of operation for x86 code, Real Mode, Protected Mode, Long Mode, Virtual 86 Mode, and System Management Mode, in which some instructions are available and others are not. A 16-bit subset of instructions is available on the 16-bit x86 processors, which are the 8086, 8088, 80186, 80188, and 80286.
With the release of the 386, protected mode offers what the Intel manuals call virtual 8086 mode. Virtual 8086 mode is designed to allow code previously written for the 8086 to run unmodified and concurrently with other tasks, without compromising security or system stability. [34] Virtual 8086 mode, however, is not completely backward ...
These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts. The updated instruction set is grouped according to architecture ( i186 , i286 , i386 , i486 , i586 / i686 ) and is referred to as (32-bit) x86 and (64-bit) x86-64 (also ...
Since addressing modes 0-3 were identical, this made 13 (electronic) addressing modes, but as in the PDP-11, the use of the Stack Pointer (R14) and Program Counter (R15) created a total of over 15 conceptual addressing modes (with the assembler program translating the source code into the actual stack-pointer or program-counter based addressing ...
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 and June 8, 1978, when it was released. The Intel 8088, released July 1, 1979, [5] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM PC design.