enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Moen Incorporated - Wikipedia

   en.wikipedia.org/wiki/Moen_Incorporated

   Most Moen kitchen, washbasin, and bathtub/shower faucets are of the single-handle design, and almost all have used the same basic water-controlling cartridge from the 1960s until 2010. Known as the Moen 1225, it is a plastic (older versions were brass) cylinder approximately 4 inches long by 3/4 inches in diameter.

3. Come-along - Wikipedia

   en.wikipedia.org/wiki/Come-along

   A come-along. A come-along, also known as a power puller, is a hand-operated winch with a ratchet used to pull objects. The drum is wrapped with wire rope.A similar tool that uses a nylon strap is used to straighten trees, as it straightens gradually over time, therefore not splitting the trunk.

4. Powder-actuated tool - Wikipedia

   en.wikipedia.org/wiki/Powder-actuated_tool

   Powder-actuated tools come in high-velocity and low-velocity types. In high-velocity tools, the propellant charge acts directly on the fastener in a process similar to a firearm. Low-velocity tools introduce a piston into the chamber. The propellant acts on the piston, which then drives the fastener into the substrate.

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   Taps and dies are tools used to create screw threads, which is called threading. Many are cutting tools; others are forming tools. A tap is used to cut or form the female portion of the mating pair (e.g. a nut). A die is used to cut or form the male portion of the mating pair (e.g. a bolt).

6. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   A go/no-go gauge is an inspection tool used to check a workpiece against its allowed tolerances via a go/no-go test. Its name is derived from two tests: the check involves the workpiece having to pass one test (go) and fail the other (no-go). For example, ISO 1502 sets a standard for screw threads and gauging to test them.